Make Your Own Awning From Pipes

Kee klamp fittings are similar to traditional threaded pipe fittings yet they connect by sliding over pipe and tightening down a set screw on the fitting.

Make your own awning from pipes.

1 1 4 pvc piping 1 bag of the cheapest cement mix you can find 4 large cans beans ketchup coffee saw measuring tape pencil white spray paint velcro sticky back squares 1 queen size sheet for the canopy 6 yards of fabric 3 in each. Start by making the frame. Attach flagpole brackets to the exterior of your house by drilling holes at the appropriate height. Before you get started here is what you are going to need.

Drill one hole about an inch down from the top of the larger pipe. Things you ll need measuring tape 1 inch pvc pipe pvc cutters 1 inch pvc elbows 1 inch pvc tees outdoor upholstery fabric or canvas pvc snap clamps 1 inch conduit clamps 2 2 inch wood screws. Diy awning step 1. You ll need 1 2 pvc pipe the t s and elbows shown here pvc cutters and.

Insert two connectors to both the ends of the side pipes to attach them to the flagpoles. Make sure you use a sturdy ladder if drilling holes that are high. The awning material is a 6 x9 canvas drop cloth. On the smaller diameter pipe drill evenly spaced holes and make sure they are at the same points on both left and right pipes.

The outer pipe has one hole and the inner pipe attached to the awning has multiple holes. Slide canvas onto frame. Dry fit the frame. This is the cheapest canvas drop cloth i.